Admix Dispensers

VSKU:

    This combination does not exist.

    Contact Us

    Admix Dispensers model no [VAC- Admix- Dispensers]


    Introduction

    The dispenser is filled with admix using the AC-151 control. Then operate the AC151 control in the MANUAL mode or activate the DISCHARGE HOLD feature for the first few dispensing cycles. This will allow sufficient time between the fill and discharge cycles to check the dispensing fittings for air or liquid leaks. Repair any leaks before operating the dispenser in production. If there are no leaks, proceed to the discharge cycle. The procedure should be repeated at least 3 times. At the end of the discharge cycle, the material level in the measuring unit should be at the zero points of the graduated measuring strip. If it is not, adjust the zero point setting. To do this, loosen the locknut at the top of the zero probes, move up or down as required. When the proper setting has been achieved, tighten the zero probe lock nut.
     

    Applications of Admix Dispensers model no [VAC- Admix- Dispensers]

    1. It can be used in concrete production

    Features of Admix Dispensers model no [VAC- Admix- Dispensers]

    1. It is available with manual, semi-automatic, or computer interface

    2. It is available with 1, 2, 3, or 4 product dispensers

    3. It is available with electric or pneumatic pumps

    We supply Admix Dispensers that can be used in various industries and applications in the United Arab Emirates. Contact us for this Admix Dispensers in Dubai, Abu Dhabi, Sharjah, RAK, UAQ, Ajman &  Fujairah too.

    This is a preview of the recently viewed products by the user.
    Once the user has seen at least one product this snippet will be visible.

    Recently viewed Products